Penstock / Sluice Gate Valve

CHANNEL PENSTOCK (Sluice)Penstock_Valve

  • Penstock for clean liquids or loaded with solids.
  • Design of square or rectangular penstock.
  • Possibility of unidirectional or bidirectional.
  • Various seal materials available.
  • Common design to embed in the walls of the channel.

General applications:

This channel penstock is designed to work in OPEN channels, and has a 3-side seal (base and sides). It is suitable to work with clean liquids or loaded with solids. Used mainly in:

  • Water treatment plants
  • Irrigation
  • Hydroelectric power stations
  • Conduits
  • Storm Drains

Working (ΔP):

The maximum working pressure is the height of the through conduit of the penstock; since these penstocks have a 3-side seal, the fluid would overflow above the through conduit whenever the fluid were higher than the through conduit.

 

WALL MOUNTED PENSTOCK (Sluice)

Penstock for clean liquids or loaded with solids.

  • Design of square or rectangular penstock.
  • Possibility of unidirectional or bidirectional.
  • Penstock for clean liquids or loaded with solids.
  • Common design to install supported on walls with chemical or expansion anchors

General applications:

This Wall Mounted penstock is designed with a 4-side seal (base and sides). For Orifice in Walls. Used mainly in:

  • Wells
  • Tanks
  • Pipe Outlets
  • Conduits

Working (ΔP):

  • Penstocks with a 4-side seal, is designed to prevent leakages of liquid is embedded.
  • Even if the fluid with maximum flow level, the fluid will be sealed within the conduit.

Pictorial:

Square or rectangular port sliding wall penstocks sealed on all 4 sides.

  • Used for on-off or control applications in wells, tanks, pipe outlets, etc.
  • Carbon or stainless steel fabricated construction, with tight sealing by means of elastomer seals.

wall_mounted_sluice_valve